Avaya ERS 8000 and Avaya VSP 9000 Implementation 認定 6103 試験問題:

1. What information do these messages determine?

A) Speed and Protocol
B) Speed and Link type
C) Speed and Duplex
D) Speed and link status

2. Refer to the exhibit.

A technician has just enabled SLPP on both core switches, and is reviewing the network diagram and console output from the core 1 Ethernet Routing Switch (ERS) 8000.
Given the output shown in the exhibit, what is the configuration error on the edge switch?

A) The edge MLT has not been configured.
B) The edge VLANs have not been configured.
C) The edge switch spanning-tree has not been configured.
D) The edge switch access port rate limiting has not been configured.

3. Once created, which ACLI command line syntax is used to see that an instance of VRF is configured correctly?

A) show sys vrf <name>
B) show ip all vrf <name>
C) show ip vrf <name>
D) show vrf <name> ip all

4. What will the boot flag ftpd do to your system on startup?

A) allow the TFTP transfer of configs
B) enable the FTP Server daemon
C) disable the FTP Server daemon
D) allow FTP traffic the highest DSCP

5. A technician is configuring a Link Aggregation connection from a stack of Ethernet Routing Switch (ERS) 5500 switches, to a core pair of ERS 8000 switches.
Which statement about the correct uplink configuration is true?

A) Enable Spanning Tree Protocol for the MLT when using it with SMLT in the core of the network.
B) Use unique MLT IDs for each stack of edge ERS 5500 switches.
C) Disable autonegotiation and replace it with VLACP to identify single fiber fault failure.
D) Distribute uplinks across different ERS 5500 switches in the stack.

質問と回答：